Sanyo PLC-XU105

53
Setting
Factory default
This function returns all setting values except for the user
logo, PIN code lock, Logo PIN code lock, lamp counter, and
filter counter to the factory default settings.
Exit the Setting Menu.
Quit
Select Factory default and this
box appears. Select [Yes], and
the next box appears.
Select [Yes] to
activate it.
Factory default
This function is used to set a frequency for the filter
cleaning.
When the projector reached a specified time between
cleanings, a Filter warning icon appears on the screen,
notifying the cleaning is necessary. After cleaning the filter,
be sure to select RESET and set the timer. The Filter
warning icon will not turn off until the filter counter is reset.
For details about resetting the timer, refer to “Resetting the
Filter Counter” on page 55.
Filter counter
Filter counter
Use the Point ◄► buttons
to set the timer. Select
from (Off/100H/ 200H/
300H) depending on the
use environment.
Filter warning icon appears on the screen at a set
time.
Fig.3
Filter warning icon
Fig.4 Filter warning icon
Note:
• This icon also appears at turning on.
Notes:
• At selecting input source, the icon (Fig.4)
will appear.
• The Filter warning icons (Fig.3 and
Fig.4) will not appear when the Display
function is set to “Off” (p.44), during
“Freeze”(p.25), or "No show" (p.26).
On 1
On 1