Sanyo plc-xu4001 User Manual

12
Part Names and Functions
To ensure safe operation, please observe the following precautions :
 Ɣ8VHWZR$$$RU/5W\SHDONDOLQHEDWWHULHV
 Ɣ$OZD\VUHSODFHEDWWHULHVLQVHWV
 Ɣ'RQRWXVHDQHZEDWWHU\ZLWKDXVHGEDWWHU\
 Ɣ$YRLGFRQWDFWZLWKZDWHURUOLTXLG
 Ɣ'RQRWH[SRVHWKHUHPRWHFRQWUROWRPRLVWXUHRUKHDW
 Ɣ'RQRWGURSWKHUHPRWHFRQWURO
 Ɣ,IWKHEDWWHU\KDVOHDNHGRQWKHUHPRWHFRQWUROFDUHIXOO\ZLSHWKHFDVHFOHDQDQGLQVWDOOQHZ
batteries.
 Ɣ5LVNRIDQH[SORVLRQLIEDWWHU\LVUHSODFHGE\DQLQFRUUHFWW\SH
 Ɣ'LVSRVHRIXVHGEDWWHULHVDFFRUGLQJWRWKHLQVWUXFWLRQVRU\RXUORFDOGLVSRVDOUXOHRUJXLGHOLQHV
Open the battery
compartment lid.
Install new batteries
into the compartment.
Replace the
compartment lid.
7ZR$$$VL]H
EDWWHULHV
For correct polarity
(+ and –), be sure
battery terminals are
in contact with pins in
compartment.
12 3
Point the remote control toward the projector
(Infrared Remote Receiver) when pressing the
buttons. Maximum operating range for the remote
control is about 16.4'(5 m) and 60 degrees in front
of the projector.
5HPRWHFRQWURO2SHUDWLQJ5DQJH
5HPRWHFRQWURO%DWWHU\,QVWDOODWLRQ
16.4'
(5 m)
30°
Remote control
30°
The 2 different remote control codes (Code
1–Code 2) are assigned to this projector.
Switching the remote control codes prevents
interference from other remote controls when
several projectors or video equipment next
to each other are operated at the same time.
Change the remote control code for the projector
first before changing that for the remote control.
See "Remote control" in the Setting Menu on
page 54.
Press and hold the MENU and IMAGE buttons
for more than five seconds to switch between
the Code 1 and Code 2. The initial code is set to
Code 1.
5HPRWH&RQWURO&RGH
0(18EXWWRQ
,0$*(EXWWRQ
:$51,1*

Sanyo plc-xu4001 Specifications

General

Brand	Sanyo
Model	plc-xu4001
Category	Projector
Language	English