Sanyo plc-xu4001 - Chapter 2 Setup Procedures

9
ENGLISH
Flow of installation
Flow of installation
To use the projector via the networks, follow the setup procedures below.
STEP 1
Connect the LAN and set the configuration.
STEP 2
Network Configuration has completed.
Decide depending on the LAN environment.
“2. Setup Procedures” (pp.11–16).
Detailed LAN configurations need to be done with a browser later.
First, complete the Wired LAN connection between computers and projec-
tors, then start browser configurations.
“3. Basic setting and operation” (pp.17–32).
Follow each chapter to operate the projector.
NOperate and manage the projector “4. Controlling the projector”(pp.33-46)
“Power Control and status check”(p.34)
“Control”(p.36)
“PC Adj.”(p.40)
“Setting up the projector”(p.41)
“Projector information”(p.44)