41
ENGLISH
Setting up the projector
Click Setting on the main menu. This function is to set up the projector.
Select the sub menu [Screen setting] or [Setting] and then set up each set-
ting.
Setting up the projector
Screen setting
This function is to adjust the screen mode of the projector. The values in the text box rep-
resent the current screen status.
Item Description
Screen .....................Switches the screen mode. {Normal,
Full, Wide(16:9), Zoom, True, Natural
wide (PLC-WU3001 Only), Custom}
There may not be available mode
depending on the input mode as
shown in the table below.
Ceiling.....................Sets the image top/bottom and left/
right reversed. (ON, OFF)
Rear...........................Sets the image left/right reversed. (ON, OFF)
Screen aspect ....Sets the aspect. {Default(16:10), 16:9, 4:3} (PLC-WU3001 Only)
Reset.........................Resets the Screen settings.
Input source
Screen mode Video PC
Normal
Full
Wide(16:9)
Zoom
True *1
Custom
The mark "" means that the available screen mode in the selected input source system.
*1 The error message appears when selecting the disabled screen mode indicated with "*1".
*2 Natural wide cannot be selected when 720p, 1035i, 1080i or 1080p is selected in AV system menu.
PLC-XU4001 Only:
Screen Aspect Default(16:10) 16:9 4:3
Input source Input source Input source
Screen mode Video PC Video PC Video PC
Normal
Full
Wide(16:9)
*1 *1
Zoom
True *1
*1
*1
Natural wide *2 *1 *2 *1 *1 *1
Custom
PLC-WU3001 Only:
To Next Page
Loading...
