Sanyo plc-xu4001 - Computer Input; Input Source and System Selection

27
Choose either &RPSXWHU5*%or &RPSXWHU5*% by pressing the COMPUTER 1 or
COMPUTER 2 button on the remote control. Or you can press the INPUT button on the top control to
choose the desired input source.
Before using these buttons, correct input source should be selected through Menu operation as
described below.
1
,QSXW0HQX
2
3
31RWH
When the Input search function is set to On 1 or
On 2 in the Auto setup function, the input signal
will be searched automatically (p.45).
Computer 1
5HPRWHFRQWURO
Press the MENU button to display the
2Q6FUHHQ0HQX8VHWKH3RLQWŸź
buttons to select ,QSXW and then press the
Point Źbutton or the SELECT button.
8VHWKH3RLQWŸźEXWWRQVWRVHOHFW
Computer 1.
When Computer 1 is selected, press the
Point ŹEXWWRQto access the submenu
items8VHWKH3RLQWŸźEXWWRQVWRVHOHFW
the 5*%input source and then press the
SELECT button.
&RPSXWHU6FDUW
,QSXW6RXUFH6HOHFWLRQ5*%&RPSXWHU&RPSXWHU
&RPSXWHU5*%
Direct Operation
Menu Operation
&RPSXWHU,QSXW
25
8VHWKH3RLQWŸźEXWWRQVWRVHOHFW
Computer 2 and then press the SELECT
button.
&20387(5EXWWRQ
&20387(5EXWWRQ
&RPSXWHU5*%
,1387EXWWRQ
7RS&RQWURO