Sanyo plc-xu4001 User Manual

26
Basic Operation
126+2:EXWWRQ
Press the P-TIMER button on the remote
control to operate the Count up/Count down
function. Refer to p.52 for detail of Setting for
the P-timer function.
To stop the count time, press the P-TIMER
button.
To cancel the P-timer function, press and hold
the P-TIMER button.
37,0(5EXWWRQ
Press the IMAGE button on the remote control
to select a desired image mode of the screen.
See pages 32, 40 for details.
,0$*(EXWWRQ
1RVKRZdisappears after 4 seconds.
31RWH
See the previous page for the description of other
buttons.
Select the screen size (See pages 34-35,
42-43 for details).
6&5((1EXWWRQ
EODFNRXWĺWKHFDSWXUHGLPDJHĺQRUPDO
ĺ
......
Press the NO SHOW button on the remote
control to black out the image. To restore to
normal, press the NO SHOW button again or
press any button. When the projected image
is captured and is set as User in the Logo
selection (p. 46), the screen changes each time
you press the NO SHOW button as follows.
31RWH
When use the MUTE button to release the
No show function, the mute function can not
be operated at the same time.
,0$*(EXWWRQ
126+2:EXWWRQ
37,0(5EXWWRQ
6&5((1EXWWRQ
5HPRWHFRQWURO
1RVKRZ
37LPHU
3,3EXWWRQ
Turn on or turn off the Picture in Picture function.
3,3EXWWRQ3/&:82QO\

Sanyo plc-xu4001 Specifications

General

Brand	Sanyo
Model	plc-xu4001
Category	Projector
Language	English