Sanyo plc-xu4001 - Page 28

28
&RPSXWHU,QSXW
3&6\VWHP0HQX
3&6\VWHP0HQX
&RPSXWHU6\VWHP6HOHFWLRQ
This projector automatically tunes to various types of computers with its Multi-scan system and Auto
PC Adjustment. If a computer is selected as a signal source, this projector automatically detects the
signal format and tunes to project a proper image without any additional settings. (Signal formats
provided in this projector are shown on page 71-72.)
One of the following messages may appear when:
When the projector cannot recognize
the connected signal conforming to
the provided PC systems, $XWR is
displayed on the System Menu box
and the Auto PC Adjustment function
works to display proper images. If
the image is not projected properly,
a manual adjustment is required (pp.
30-31).
There is no signal input from the
computer. Check the connection
between your computer and the
projector. (See “Troubleshooting” on
pp. 65-67)
$XWR
- - - -
The preset system is manually
adjusted in the PC adjust Menu. The
adjusted data can be stored in Mode
1-10 (pp. 30-31).
Mode 1
PC Systems provided in this projector
is chosen. The projector chooses
a proper system provided in the
projector and displays it.
69*$
*Mode 1 and 69*$ are examples.
1
2
PC system can also be selected manually.
Selecting Computer System Manually
Press the MENU button to display the
2Q6FUHHQ0HQX8VHWKH3RLQWŸźEXWWRQV
to select ,QSXW and then press the Point Ź
button or the SELECT button.
8VHWKH3RLQWŸźEXWWRQVWRVHOHFW6\VWHP
and then press the Point Źbutton or the
SELECT button.
8VHWKH3RLQWŸźEXWWRQVWRVHOHFWWKH
desired system and then press the SELECT
button.
3
Selected system in
the PC System Menu
is displayed.
Systems in this dialog box
can be selected.
Customized Mode
± set in the PC
adjust Menu (pp.
30-31).