Sanyo plc-xu4001 User Manual

66
$SSHQGL[
No image – Check the connection between your computer or video
equipment and the projector. See pages 14-16.
– See if the input signal is correctly output from your computer.
Some laptop computers may need to change the setting for
monitor output when connecting to a projector. See your
computer’s instruction manual for the setting.
– It takes about 30 seconds to display an image after turning on
the projector. See page 18.
– Check the Input signal, color system, video system or computer
system mode.
– Make sure the temperature is not out of the specified Operating
  7HPSHUDWXUHÛ)±Û)>Û&±Û&@
– When 1RVKRZis operating, the image cannot be displayed.
Press the NO SHOW button or any other button on the
remote control.
No sound – Check the audio cable connection from audio input source.
– Adjust the audio source.
– Press the VOLUME + button. See page 24.
– Press the MUTE button. See page 24.
– When the AUDIO OUT is plugged-in, the projector's built-in
speaker is not available.
– Is the image projected? You will hear the Computer and VIDEO
sound only when the image is projected.
 7KHFRORULVVWUDQJH – Check the Input signal, color system, video system or computer
system mode.
– Make sure the %ODFNERDUG is not selected on Image select
menu. See pages 32, 39.
 6RPHGLVSOD\VDUHQRWVHHQ – Check the Display function. See page 46.
GXULQJWKHRSHUDWLRQ
$XWR3&DGMXVWPHQWIXQFWLRQ – Check the Input signal. Auto PC adjustment function can not
does not work. work when 480p, 575p, 720p, 480i, 575i, 1035i or 1080i is
selected (see page 29), or when the signal is coming from the
HDMI terminal.
7KHVHWWLQJGRHVQRWUHPDLQ – Make sure you selected Store after adjusting setting. Some
DIWHUWXUQLQJRIISRZHU settings can not be stored if not registered with Store. See
pages 33, 41.
Power management – Power management function can not work while )UHH]H
does not work. or 1RVKRZ function is running. See page 49.
&DSWXUHIXQFWLRQGRHV– Check the connection and the input signal to see if there is
not work. signal.
$XWRVHWXSGRHVQRW –
Make sure 2II is not selected at any function of$XWRVHWXS.
ZRUNSURSHUO\ See page 45.
– Make sure On is not selected at the Ceiling function.
See pages 35, 43.
 $XWRNH\VWRQHIXQFWLRQGRHVQRW – Make sure the Auto keystone function is not set to Manual.
ZRUNHYHQZKHQWKHSURMHFWRULV Press the AUTO SETUP button on the top control. See
tipped. pages 23, 45.

Sanyo plc-xu4001 Specifications

General

Brand	Sanyo
Model	plc-xu4001
Category	Projector
Language	English