Sanyo PLC-XU74 - For Zooming in and out the Images

Computer Input
33
When the Digital zoom + is selected, the On-Screen
Menu disappears and the message "D. zoom +" is
displayed. Press the SELECT button to expand the
image size. And press the Point ed 7 8 buttons to
pan the image. The Panning function can work only
when the image is larger than the screen size.
A projected image can be also expanded by pressing
the D.ZOOM e button on the remote control.
Digital zoom +
When Digital zoom – is selected, the On-Screen Menu
disappears and the message "D. zoom –" is displayed.
Press the SELECT button to compress image size.
A projected image can be also compressed by pressing
the D.ZOOM d button on the remote control.
To exit the Digital zoom +/– mode, press any button
except the D.ZOOM ed buttons, SELECT, and Point
buttons.
To return to the previous screen size, select a screen
size from the Screen Size Adjustment or select an input
source from the Input Source Selection (p.25) again, or
adjust the screen size with the D.ZOOM ed buttons.
Digital zoom –
For zooming in and out the images
Remote Control
D.ZOOM + button
POINT buttons
SELECT button
D.ZOOM - button
✔ Note:
• T h e p a nni n g f u ncti o n m a y n o t
operate properly if the stored Mode
in the PC Adjust Menu is used.
(p.29)
• The minimum compression ratio
can be limited depending on the
input signal or when the Keystone
function is working.
• True, Full screen, and Digital zoom
+/– cannot be selected when 480i,
575i, 480p, or 575p is selected in
the PC System Menu (p.26).
• Digital zoom +/- cannot be selected
when Full screen or True is selected.
Computer Input