9
Part Names and Functions
Part Names and Functions
Part Names and Functions
Rear Terminal
q w e r t y
i
u
✽
o
r COMPUTER IN 2 / MONITOR OUT
This terminal is switchable and can be
used for input from a computer and video
eq u i pment (component or RG B scart
21-pin) or output to the other monitor.
Set the terminal up as either Computer
input or Monitor output properly. (Used
for Monitor out, this terminal outputs only
incoming signal from COMPUTER IN 1/
COMPONENT IN terminal.) (p15, 17, 46)
q USB (Series B)
In order to operate the computer with
the remote control during a presentation,
connect the USB port of the computer to the
projector with a USB cable. (p.15)
w SERVICE PORT
This jack is used to service the projector.
e COMPUTER IN 1/COMPONENT IN
Connect output signal from a computer,
R G B s c a r t 2 1 - p i n v i d e o o u t p u t , o r
component video output to this terminal.
(p.15, 17)
When the cable is of the longer variety, it
is advisable to use this terminal and not
COMPUTER IN 2/MONITOR OUT.
RESET button
A built-in micro processor which controls this
unit may occasionally malfunction and need
to be reset. This can be done by pressing
the RESET button with a pen, which will
shut down and restart the unit. Do not use
the RESET function excessively.
t S-VIDEO IN
Connect the S-VIDEO output from video
equipment to this jack. (p.16)
y AUDIO IN
Connec t t he audio ou tput fr o m video
equipment connected to t or o to this
jack. (When the audio output is monaural,
connect it to L (MONO) jack.) (p.16)
i COMPUTER/ COMPONENT AUDIO IN
Connect the audio output (stereo) from a
computer or video equipment connected to
e or r to this jack. (p 15, 17)
o VIDEO IN
Connect the composite video output from
video equipment to VIDEO jack. (p.16)
u AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this
jack. (p.15 - 17)
This terminal outputs sound from AUDIO IN
terminal (y or i).
✽
To Next Page
Loading...
