3
3 - 67
Control of Mini ECO-i SYSTEM
5. Schedule Timer
I Setting Errors
If time is set as shown below while setting up a program, “ERROR” is displayed (the indication blinks).
Therefore, correct the time setting.
If Program Times are the Same
Example of Time Settings That Do Not Cause Errors
The below time settings do not generate an error.
STEP 1 Every time the SET button is pressed, the setting mode switches between programmed operations of
the same time setting ( and in the above example), therefore select the time setting to correct.
STEP 2 Change the time setting with the HH and MM buttons so that the times are no longer the same.
STEP 3 Press the SET button and check “ERROR” is not displayed.
STEP 4 Press the PROGRAM button to end the setting mode.
1) When ON and OFF times are staggered 2) When OFF time is earlier than ON time
06-405 Mini-ECOi_TD3 11/6/06 6:18 PM Page 67
To Next Page
Loading...
