3
3 - 42
Control of Mini ECO-i SYSTEM
4. System Controller
I Display
Description
A: When the unit is in heating standby status, the indicator appears.
B: The currently selected operation mode is displayed.
C: The currently selected FAN SPEED, Airflow Direction and SWEEP settings are
displayed.
D: This indication appears when the filter needs cleaning.
E: This indication appears only when an abnormality occurs within a unit.
F: The currently selected mode (ALL, ZONE or GROUP), ZONE number and GROUP
number are displayed.
G: The currently selected central control mode (1, 2, 3 or 4) is displayed.
H: Lights when any of the air conditioners under the system control is operating; turns off
when none of the air conditioners under the system control is operating. Blinks when
any conditioner is operating under abnormal conditions and its protection function
is working.
I: When the button is pressed for more than 4 seconds, the TEST indicator
appears.
J: This indication appears when the temperature is set.
K: When turning on the power switch of the system controller, sign blinks for a few
minutes. While blinking, any controls using the system controller are inhibited. This is
because the system controller is verifyin
connected
roups.
A
B
C
D
E
F
G
H
I
J
K
GROUP number display (no figure: no number registered)
GROUP state display ( : registered group, : currently selected
group)
Operation state display ( : on, no sign: off, : alarm)
06-405 Mini-ECOi_TD3 11/6/06 6:18 PM Page 42
To Next Page
Loading...
