3
3 - 78
Control of Mini ECO-i SYSTEM
5. Schedule Timer
I Troubleshooting
Before requesting servicing, check the following.
If trouble persists despite taking the above action, stop the schedule timer, turn off the unit and report the serial
number and problem to your dealer. Never service the unit yourself as this is dan
erous.
Trouble Cause/Remedy
Check before requesting servicing
blinks on the display. The schedule timer is performing initial
communications with connected indoor units. Wait for
communications to finish.
Air conditioners do not operate as scheduled when
the set time comes.
The timer has been disabled. (Refer to
A holiday has been scheduled. (Refer to
Air conditioners can be started and stopped from
the remote controller even though the program
disables remote controller operation.
Power to the air conditioner was lost and
subsequently restored. (Refer to
blinks in the present time display area. Power to the air conditioner was lost for a long period
of time. Set the present time and today’s day of the
week again. (Refer
to
pages 3-67
pages 3-64 and 3-65.)
page 3-74.)
page 3-78.)
and 3-77.)
06-405 Mini-ECOi_TD3 11/6/06 6:18 PM Page 78
To Next Page
Loading...
