3
3 - 72
Control of Mini ECO-i SYSTEM
5. Schedule Timer
NOTE
If a program already exists in the copy destination group, the newly copied program overwrites the
existing program.
If you accidentally copy over a program in the group program copy mode, holding down the CANCEL
button for more than 2 seconds returns the program to the point prior to pressing the PROG. COPY
GROUP button in STEP 1. (All changes and copy operations made up until that point are cleared.)
STEP 5 Select other copy destination groups if desired.
•
•
•
You can copy the selected source group programs
into other groups by repeatedly pressing the
GROUP button to select a group followed by the
SET button to set it.
NOTE
If a group from numbers 1 to 4 was selected as the
copy destination group, that number appears in the
program area. If a group from numbers 5 to 8
was selected, that number appears in the program
area.
STEP 6 Press the PROG. COPY GROUP button to enter the
copied programs in the selected groups.
•
•
The normal display returns.
06-405 Mini-ECOi_TD3 11/6/06 6:18 PM Page 72
To Next Page
Loading...
