EasyManua.ls Logo

Sanyo SPW-CR605GXH8 - Page 276

Sanyo SPW-CR605GXH8
345 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
4 - 134
Mini ECO-i SYSTEM Unit Specifications
8. Concealed Duct High Static Pressure Type (D Type)
8-4. Noise Criterion Curves
MODEL : SPW-DR254GXH56(A/B)
SOUND LEVEL : HIGH 44 dB(A), NC
38
CONDITION : Under the unit
1.5 m
SOURCE : 220 - 230 - 240 V, Single-phase, 50 Hz
MODEL :
SPW-DR484GXH56(A/B)
SOUND LEVEL : HIGH 47 dB(A), NC
42
CONDITION : Under the unit
1.5 m
SOURCE : 220 - 230 - 240 V, Single-phase, 50 Hz
MODEL :
SPW-DR364GXH56(A/B)
SOUND LEVEL : HIGH 45 dB(A), NC
39
CONDITION : Under the unit
1.5 m
SOURCE :
220 - 230 - 240 V, Single-phase, 50 Hz
90
80
70
60
50
40
30
20
10
APPROXIMATE
THRESHOLD OF
HEARING FOR
CONTINUOUS
NOISE
63 125 250 500 1000 2000 4000 8000
NC-70
NC-60
NC-50
NC-40
NC-30
NC-20
90
80
70
60
50
40
30
20
10
APPROXIMATE
THRESHOLD OF
HEARING FOR
CONTINUOUS
NOISE
63 125 250 500 1000 2000 4000 8000
NC-70
NC-60
NC-50
NC-40
NC-30
NC-20
REMARKS: 1. Value obtained in the actual place
where the unit is installed may be
slightly higher than the values shown in
this graph because of the conditions of
operation, the structure of the building,
the background noise and other factors.
2. The test results were obtained from an
anechoic room.
NOTE
90
80
70
60
50
40
30
20
10
APPROXIMATE
THRESHOLD OF
HEARING FOR
CONTINUOUS
NOISE
63 125 250 500 1000 2000 4000 8000
NC-70
NC-60
NC-50
NC-40
NC-30
NC-20
Sound Pressure Level (dB)
(0 dB = 0.0002 µbar)
Sound Pressure Level (dB)
(0 dB = 0.0002 µbar)
Frequency at center of sound pressure band (Hz) Frequency at center of sound pressure band (Hz)
Sound Pressure Level (dB)
(0 dB = 0.0002 µbar)
Frequency at center of sound pressure band (Hz)
To evaluate the noise level, the maximum value of the
measured sound pressure level is used. Read the value
at each frequency level (on horizontal axis, center of the
sound pressure band) from 63 Hz to 8000 Hz, and
select the corresponding maximum value indicated on
the vertical axis.
06-405 Mini-ECOi_TD4 11/8/06 4:28 PM Page 134

Table of Contents

Related product manuals