3
3 - 27
Control of Mini ECO-i SYSTEM
3. Wired Remote Controller
F: FILTER button This button is used to turn off the filter sign ( ). When the filter sign appears
on the display, clean the filter, and then press this button to turn off the sign.
G: CHECK button This button is used only when servicing the air conditioner.
Do not use the CHECK button for normal operation.
H: UNIT button When more than one indoor unit is connected, this button is used to select a
unit when adjusting the airflow direction.
If no unit is selected, the airflow direction of all units can be adjusted
concurrently using the FLAP button.
I: FLAP button 1. Use this button to set the airflow direction to a specific angle.
The airflow direction is displayed on the remote control unit.
Operation mode
Number of airflow direction se
ttings
(COOL) or (DRY) 3
(HEAT) or (FAN) 5
(AUTO)
Cooling mode: 3
Heating mode: 5
In the Cool mode and Dry mode, if the flaps are set in a downward
position, condensation may form and drip around the vent.
Do not move the flap with your hands.
This function is available only for models X, LD, S, T and K.
(SWEEP) 2. Use this button to make the airflow direction sweep up and down
automatically.
Press this button several times until the symbol appears on the
display.
To stop the swing operation
Press the FLAP button again during the flap swing operation to stop the flap
at the desired position. Then, the airflow can be set from the top position by
pressing the FLAP button again.
Indicator when swing operation is stopped
During cooling and drying, the flap does not stop at the downward position.
Even if the flap is stopped at the downward position during the swing
operation, it does not stop until it moves to the third position from the top.
This function is available only for models X, LD, S, T a
nd K.
CAUTION
CAUTION
NOTE
Fan and heating Cooling and drying
NOTE
●
●
06-405 Mini-ECOi_TD3 11/6/06 6:18 PM Page 27
To Next Page
Loading...
