Part Names and Functions
1 2 3
To ensure safe operation, please observe the following precautions:
lUse two (2) AA or LR6 type alkaline batteries.
lAlways replace batteries in sets.
lDo not use a new battery with a used battery.
lAvoid contact with water or liquid matter.
lDo not expose the remote control to moisture or heat.
lDo not drop the remote control.
lIf the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
lRisk of explosion if a battery is replaced by an incorrect type.
lDispose of used batteries according to the instructions or your local disposal rule and guidelines.
Open the battery
compartment lid.
Install new batteries into
the compartment.
Replace the
compartment lid.
Two AA size batteries
For correct polarity (+ and –),
be sure battery terminals are
in contact with pins in the
compartment.
Point the remote control toward the projector
(Infrared Remote Receiver) when pressing
any button. See the right figures indicating
Maximum operating range for the remote
control.
Operating Range
Remote Control Battery Installation
13
16.4’
(5 m)
11.5’
(3.5 m)
16.4’
(5 m)
To Next Page
Loading...
Need help?
General