Operating Instructions BioPAT
®
Xgas 11
Design and Function
Electronics
Pressure and humidity
measurement
CO
2
IR sensor
ZrO
2
O
2
sensor
For hoses | pipes
Fig. 1: Schematic illustration of complete installation
In order to prevent humidity contained in the exhaust air in the BioPAT
®
Xgas
from condensing, the sensor housing is heated. Warming up prior to initial
startup as well as every time the device is disconnected from the power
supply will take about an hour. The sensor won’t provide any valid readings
during heating.
To Next Page
Loading...
