Utilities for Printouts or Data Transfer
Sartorius balances come standard with an interface. You can plug a Sartorius
printer or a computer into this interface port. In addition, you can choose to have
data output from your balance to this on-line device either automatically or by
pressing the p key.
The balance operating menu lets you define the various parameters for data output.
Information on the data formats and for interfacing a computer or a different
peripheral device are available on request.
Data Output Parameter
This parameter is coupled with the stability parameter
Print on request = data is output only when the p key is pressed or a software
command is received
Auto print = continuous, automatic data output
Code
Print on request regardless of stability 6 1 1
Print on request after stability, with storage of the function 6 1 2*
Print on request at stability, without storage of the function 6 1 3
Auto print regardless of stability 6 1 4
Auto print at stability 6 1 5
Auto Print
You can stop and start automatic data output (auto print function) by pressing
the p key.
Code
Start/stop auto print using the p key 6 2 1
Auto print not stoppable 6 2 2*
Data Output at Defined Intervals
The menu code for “2 display updates” must be set if you connect the remote
display to the balance.
Auto print interval Code
1 display update 6 3 1*
2 display updates 6 3 2
* = factory setting
36
To Next Page
Loading...
Need help?
General