Special Codes
Special codes are output only if the balance operating menu code 611, 614
or 615 is set (see the section entitled “Data Ouput Parameters”).
Special status-dependent codes
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
The following status codes are output for “A B”:
**: Tare H*: Overload
C*: Calibrate*) L *: Underload
––: All numerals indicated in stable readout
Special error-dependent codes
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
X= *, 0,1or 2 as a one-place error code
Y Z = two-place error index code
*= space
*) = The displayed status code “C” will also be output when a print command
is received and if the balance has a built-in calibration weight
***
ERR
*
XYZ
****
CR LF
******
AB
******
CR LF
58
To Next Page
Loading...
Need help?
General