Sartorius Entris - Installation; Setting up Balances with Draft Shields; Setting up Balances with Weighing Pans

Installation
Setting up the Balance
Balances with Sliding Panel Draft Shield
t Place the components listed below inside the
weighing chamber in the order given:
– Shield plate
– Shield disk
– Pan support
– Weighing pan
Balances with Round Glass Draft Shield
t Position the components listed below in the order
given:
– Place lid on top of the balance with the rim facing
upwards and rotate until it is securely in place
– Pan support
– Weighing pan
– Glass cover
– Cover with the rim facing downwards
Balances with a Round Weighing Pan
t Position the components listed below in the order
given:
– Pan support
– Weighing pan
Balances with a Rectangular Weighing Pan
t Place the weighing pan on the balance
6