29
Toggling between Weight Units
Purpose
With this application program you can change the weight value displayed from the basic
weight unit to any of 4 application weight units (see table on next page).
Features
– Set the basic unit and display accuracy in the Setup menu:
see “Configuration".
– Set the application weight units and display accuracies in the Application menu.
– These settings are stored in battery-backed memory.
– The basic unit is active when the balance is powered up.
Example: Change display from the basic unit (in this example, grams [g]) to pounds [lb]
and Troy ounces [ozt].
Set the following parameters: Applic. - unit (code 2. 2.)
Step Press key Display | Printout
Preparation:
1. Begin selection of an
b NONE
o
application weight unit
2. Select an application unit,
in this example “pounds" Repeatedly:
(see table on next page)
b pounds
3. Confirm the weight unit (pounds)
u pounds
o
4. Select the next application weight u, NONE
o
unit, in this example: Troy ounces Repeatedly:
(see table on next page)
b troy.oz.
5. Confirm weight unit (Troy ounces)
u troy.oz.
o
6. Select other application units if desired (max. 4 total)
(otherwise, confirm “NO" by pressing
u)
7. Store selection
c 0.00 g
Conversion:
8. Place sample on balance +
100.00 g
9. Toggle unit for weight value Repeatedly: + 0.22046 lb
u + 3.5275 ozt
To Next Page
Loading...
