Sartorius Entris - Data Interface

Purpose
Your balance comes equipped with
an interface port for connection to a
computer or other peripheral device.
You can use an on-line computer to
change, start and/or monitor the functions
of the balance and the application
programs.
Female interface connector
1
14
13
25
Pin Assignment Chart, 25-pin, RS-232:
Pin 1: Shield
Pin 2: Data output (TxD)
Pin 3: Data input (RxD)
Pin 4: Internal ground (GND)
Pin 5: Clear to Send (CTS)
Pin 6: Not connected
Pin 7: Internal ground (GND)
Pin 8: Internal ground (GND)
Pin 9: Not connected
Pin 10: Not assigned
Pin 11: + 12 V (operating voltage
for Sartorius printer)
Pin 12: Reset _ Out
Pin 13: + 5 V
Pin 14: Internal ground (GND)
Pin 15: Universal remote switch
Pin 16: Not connected
Pin 17: Not connected
Pin 18: Not connected
Pin 19: Not connected
Pin 20: Data Terminal Ready (DTR)
Pin 21: Not connected
Pin 22: Not connected
Pin 23: Not connected
Pin 24: Not connected
Pin 25: + 5 V
*) = Hardware restart
34
Data Interface
Preparation
You can set these parameters for other
devices in the Setup menu:
see “Configuration".
You will also find a detailed description
of the available data interface commands
in the file “Data Interface Descriptions for
Entris Models", which you can download
from the Sartorius website:
(www.sartorius.com
"Download Center".)
For remote switch*)