Net-total Formulation
Display symbol: R
Purpose
With this application program you can
weigh in different components up to
a defined total. You can print out both
the total weight and the individual
weights of the components.
Features
– Weigh up to 99 components from “0”
to a defined total component weight.
– Store component weights (“Store xx
comp.”), with
– display zeroed automatically after
value is stored, and
– automatic printout
– Clear component memory following
cancellation of the weighing sequence
(by pressing c) and printout of the
total weight.
– Toggling between component weight
and total weight by pressing and
holding b (< 2 sec).
– Printout of the total of the individual
component weights (T-Comp)
Preparation
§ Select the Net-total application in the
menu:
see “Configuration.”
§ Set the following parameters:
Applic. Application program
Net-TotL. Net-total formulation
Comp.Prt. Printout of components
Off
o On
o = Factory setting
Printout: Net-total formulation
Comp 2+ 278.1 g : Second
component
T-Comp+ 2117.5 g : Sum of
components
34
To Next Page
Loading...
Need help?
General