8
Operation
The weight display shows the following special
Status messages for your information:
BUSY
The balance processor is still busy processing a function and
will not accept any other commands to perform functions at this
time.
STANDBY
The display has been turned off with the ON/OFF key
(9)
and
the balance is now in the ready-to-operate state so that it does
not require warmup.
POWER OFF
The balance has been disconnected from line power (power
failure or outage, reconnection to line power after the balance
has been unplugged).
CAL
The calibration function has been activated.
To Next Page
Loading...
Need help?
General