5
Shielded Cables
Connections between the devices
and peripherials must be made
using shielded cables in order to
maintain compliance with FCC
radio frequency emission limits.
Modifications
Any modifications made to this
device that are not approved by
Sartorius Stedim Biotech GmbH
may void the authority granted
to the user by the FCC to operate
this equipment.
1.2 FCC
Note:
This equipment has been tested
and found to comply with the
limits for a Class B digital device,
pursuant to part 15 of the FCC
Rules. These limits are designed
to provide reasonable protection
against harmful interference in
a residential installation. This
equipment generates, uses and
can radiate radio frequency energy
and, if not installed and used in
accordance with the instructions,
may cause harmful interference to
radio communications. However,
there is no guarantee that interfer-
ence will not occur in a particular
installation. If this equipment
does cause harmful interference to
radio or television reception, which
can be determined by turning the
equipment off and on, the user is
encouraged to try to correct the
interference by one or more of the
following measures:
– Reorient or relocate the receiving
antenna.
– Increase the separation between
the equipment and receiver.
– Connect the equipment into
an outlet on a circuit different
from that to which the receiver
is connected.
– Consult the dealer or an experi-
enced radio|TV technician for help.
To Next Page
Loading...