50
Aut12628.jpg
M
D
K
I
AUT12751a.JPG
J
J
Aut12761b.JPG
K
L
M
L
Replacing the Data Output Port
In the case of defects, do not attempt to make any repairs at the component
level, but replace the entire data output port (D) with the pan support (K).
– Open the balance/scale (see page 48)
– Disconnect the ribbon cable (I) that leads to the display PCB.
– Lay the upper part of the housing to one side.
– Remove the four nuts (J).
– Disconnect the plugs from the output port (M) and power socket (L).
– Remove the base plate from the pan support..
– Replace the pan support with the data output port.
– Once replacement is completed, close the balance/scale.
– Then check the data output port for correct functioning. If possible, test the
port with the following devices:
– Sartorius printer, e.g., model YDP03-OCE
– Service software (such as „SBI-Test“)
– Data capture software for PCs and laptops, such as „Balance Reader“
To Next Page
Loading...