If the automatic taring function (-A2-) is switched
off:
§ Remove the sample from the weighing pan
§ Place the next sample on the weighing pan
§ Press the key to store the value
> Measured values are printed (see example on the
left)
If the automatic taring function (-A2-) is switched
on:
§ Leave the first sample on the weighing pan
§ Add the next sample to the one already on the
weighing pan
§ Make sure the total weight does not exceed the
weighing instrument’s maximum capacity (if it does,
“H” is displayed)
§ Press the key to store the value
> The value is printed
§ Continue as described above until all samples have
been weighed
§ Press the key to print the statistics
> Calculated values are printed (see example on the
left)
> After printing, the measured values are deleted from
the printer’s memory
Vartext1, Vartext2
You can define a header of up to two lines, with
up to 24 characters per line. The header lines are
designated “Vartext1” and “Vartext2” and are stored
in the printer’s non-volatile memory. For details on
defining header texts, see page 21 in the chapter
entitled “Configuration”.
14
To Next Page
Loading...
