Recording and Evaluating Data
§ Press the key to clear the statistics memory prior
to initial data transfer
> Any values in memory are evaluated and the results
printed
§ Place the first sample on the weighing pan
§ Press the key to store the measured value
> The total number of transactions is displayed
(see example on the left)
> “STAT” is displayed for approximately 0.5 sec.
> The measured value is stored in the statistics
memory as the reference value
If the automatic taring function is switched off:
§ Remove the sample from the weighing pan
§ Place the first sample on the weighing pan
> The value is stored automatically once the weighing
instrument has stabilized
> Measured values are printed (see example on the left)
If the automatic taring function is switched on:
> The weighing instrument is tared automatically after
initial data transfer
§ Leave the first sample on the weighing pan
§ Add the next sample to the one already on the
weighing pan
§ Make sure the total weight does not exceed the
weighing instrument’s maximum capacity (if it does,
“H” is displayed)
> The value is stored automatically once the weighing
instrument has stabilized
> The value is printed
16
To Next Page
Loading...
