Satel Integra 24 - Answering Phone Calls and Remote Control; Telephone Answering and Control Parameters and Options; Users and Remote Switches; Activation of the Phone Calls Answering

108 Programming SATEL
14. Answering phone calls and remote control
The call answering function allows the control panel users to receive information on
the partition status (arm mode, alarms). Owing to the telephone control function, the users
can control the REMOTE SWITCH outputs by means of a telephone.
The INT-VG module offers a much larger scope of the alarm system remote operation
functionality using a telephone.
The parameters of telephone answering and control can be programmed:
• using the keypad, in the service mode, by means of the functions available in the
TEL.ANSW./CTRL. submenu,
• using the DLOADX program, in the “Answering and remote control” window.
14.1 Telephone answering and control parameters and options
See also section “Telephone options” p. 71.
Shown in square brackets are the names used in keypads.
Answer if all chosen partitions are armed [On armed part.] – you can indicate the
partitions whose status will affect the telephone answering and control functions (they will
only be executed, if all indicated partitions are armed).
If the ANSWERING - MODEM option is enabled, the control panel will be answering
the calls whether the partitions are armed or not.
14.1.1 Users and remote switches
The telephone control function requires that REMOTE SWITCH type outputs, which can be
controlled by users, be individually assigned to each user.
Fig. 14. “Answering and remote control” window in the DLOADX program.
14.2 Activation of the phone calls answering
1. Enable the ANSWERING - AUDIO option.
2. Define the rules of call answering by the control panel (RINGS BEFORE ANSWER parameter
and DOUBLE CALL option).