SATEL INTEGRA 33
Connection – select the set of parameters that will be used for establishing communication:
SERVER, PORT and DLOADX KEY.
LAN/WAN – you can enter the parameters yourself. These can be parameters needed for
the Wide Area Network (WAN) or Local Area Network (LAN) communication.
LAN: ETHM-1, Address n [n=module address] – settings of the ETHM-1 Plus / ETHM-1
module with the given address will be used (the module network address will not be
read if it is downloaded from the DHCP server). These settings can only be used for the
needs of LAN communication.
Server – address of the Ethernet module. If the Ethernet module is not in the same local
network as the computer with DLOADX program, it must be a public address. You can
enter either the IP address or the domain name.
Port – the number of TCP port used for communication between the control panel and
computer with DLOADX program using the ETHM-1 Plus (INT-GSM / INT-GSM LTE
module connected to the ETHM-1 Plus) / ETHM-1 module. You can enter a value from 1 to
65535. Default value: 7090.
DLOADX key – a string of up to 12 alphanumeric characters (digits, letters and special
characters), used for data encryption during communication between the control panel and
the computer with DLOADX program using the ETHM-1 Plus / ETHM-1 / INT-GSM /
INT-GSM LTE module.
SATEL server
The settings below apply to communication with the module via the SATEL server.
Connection – select the set of parameters that will be used for establishing communication:
ETHM-1 ID, ETHM-1 MAC and DLOADX KEY.
MAC (ETHM-1) – you can enter the parameters yourself.
Module: ETHM-1, Address n [n=module address] – settings of the ETHM-1 Plus module
with the given address will be used.
ETHM-1 ID – individual identification number assigned to the ETHM-1 Plus module by the
SATEL server.
ETHM-1 MAC – hardware address of Ethernet module.
DLOADX key – a string of up to 12 alphanumeric characters (digits, letters and special
characters), used for data encryption during communication between the control panel and
the computer with DLOADX program using the ETHM-1 Plus / ETHM-1 / INT-GSM /
INT-GSM LTE module.
3.2.4 Cellular data network communication parameters
Programming the parameters
Control panel settings
Settings related to working in conjunction with the INT-GSM / INT-GSM LTE module / GSM
module which enables cellular data network communication (LTE/GPRS) can be configured
when programming the telephone options (see: “Telephone options” p. 71).
For the INTEGRA 128-WRL control panel, the cellular data network (GPRS) communication
settings can be configured when configuring the GSM communicator (see: “GSM phone”
p. 79).
INT-GSM / INT-GSM LTE module / GSM module settings
For description of parameters and options, please refer to the INT-GSM / INT-GSM LTE
module / GSM module manual.
To Next Page
Loading...
