96 Programming SATEL
2. GSM communicator [INTEGRA 128-WRL control panel] / SATEL GSM module [any
control panel] for transmission via the cellular data network (GPRS/LTE).
3. GSM communicator to send SMS [INTEGRA 128-WRL control panel],
4. analog telephone line [INTEGRA 128, INTEGRA 64, INTEGRA 32 or INTEGRA 24 control
panel] / GSM voice channel [INTEGRA 128-WRL control panel] (basic and backup
telephone number).
If the event code is successfully sent via one transmission path, the other transmission paths
will not be used.
If sending the event code via one transmission path fails, the control panel will try to send the
event code by using the next transmission path. In the case of reporting via the telephone
line, if the event cannot be sent despite completion of the preprogrammed number of retries,
the control panel will hang up until a next event occurs, or for a specified period of time. After
the time expires, the control panel will make further attempts to send the event.
The reporting parameters can be programmed:
• using the keypad, in the service mode, by means of the functions available in the
MONITORING submenu,
• using the DLOADX program, in the “Reporting” window.
For correct operation, the reporting function may require enabling some system options.
Reporting through the ETHM-1 Plus / ETHM-1 / INT-GSM / INT-GSM LTE / GSM modules
requires that some telephone options be enabled and settings of these modules properly
configured.
Before you proceed to the programming, obtain from the monitoring station operator all data
necessary to correctly start the reporting function:
• depending on the method of sending events:
– telephone number of the monitoring station (telephone reporting),
– server address, port number, STATION KEY and KEY (ETHM) (reporting through Ethernet
network),
– server address, port number, STATION KEY and KEY (GPRS) (reporting via the cellular
data network),
– telephone number of the monitoring station and SMS message format (SMS reporting),
• transmission format required by the monitoring station,
• identifiers assigned to the alarm system,
• list of event codes (not applicable to Contact ID and SIA formats).
12.1 Reporting parameters and options
See also section “Telephone options” p. 71.
Shown in square brackets are the names used in keypads.
12.1.1 Options
Station 1 or Station 2 – the control panel will make an attempt to send the event code to
station 1 and, if unsuccessful, to station 2.
Station 1 only – the event codes are only sent to station 1.
Station 2 only – the event codes are only sent to station 2.
Station 1 and 2 – the event codes are sent to both stations. For most formats, it is possible
then to define which events will be sent to the given station (see: EVENTS ASSIGNMENT).
Dual path reporting – the option is available when the ETHM-1 Plus module with the
INT-GSM / INT-GSM LTE module attached to it is connected to the control panel. The
To Next Page
Loading...
