SATEL INTEGRA 37
4. The DLOADX program will inform you about establishing connection by means of
a suitable message.
Connection initialized from the DLOADX program, but the control panel calls
back and sets up the connection
Control panel settings:
• program the telephone number of modem connected to computer,
• if an external modem is connected to the control panel, enable the EXTERNAL MODEM
option,
• if a GSM or ISDN modem is connected to the control panel, enable the MODEM
ISDN/GSM/ETHM option,
• enable the ANSWERING – MODEM option [any modem] or the ANSWERING – ETHM/GSM
option [recommended for GSM or ISDN modem],
• define the number of rings after which the control panel will answer incoming calls (RINGS
BEFORE ANSWER
) [this does not apply to the GSM or ISDN modem],
• enable the DOUBLE CALL option if the control panel is to answer only after the second call
[this does not apply to the GSM or ISDN modem].
DLOADX program settings:
• program the telephone number of control panel,
• configure the modem communication parameters.
1. Click on the button in the DLOADX program.
2. A drop-down menu will be displayed. Select in it the appropriate control panel modem (in
case of the INTEGRA 128-WRL control panel, select “Modem - INTEGRA with ext.
modem” for CSD communication). A window will open in which information on the modem
initialization will be displayed.
3. Click on the “Connect” button.
4. The control panel will answer, confirm answering the connection, hang up, and then call
back the programmed computer telephone number.
5. The DLOADX program will answer the connection automatically or the program user must
accept establishing the communication (which depends on the settings programmed in
the “Configuration” window, “Modem” tab). A suitable message will inform about the
connection being established.
Connection initiated by SMS message
Control panel settings:
• program the telephone number of modem connected to computer,
• enable the EXTERNAL MODEM and MODEM ISDN/GSM/ETHM options.
And additionally, for the INTEGRA 128-WRL control panel:
• program the control command, which will be sent in the SMS message to initiate
communication between the control panel and the DLOADX program,
• configure the GSM communicator.
DLOADX program settings:
• configure the modem communication parameters.
If communication is to take place through the SATEL GSM module connected to the control
panel, configure settings of the module (see: GSM module manual).
To Next Page
Loading...
