82 Programming SATEL
Zone disabling CHIME [Chime bps. zone] – zone, which, if violated, will disable the CHIME
feature for specified time.
Bypass time [Chime bps. time] – time during which the CHIME signal will be disabled after
violation of the zone which disables the signaling (time is counted from the zone restore). If
the value 0 is programmed, the signaling will not be disabled.
Quick Arm partitions [Quickarm part.] – partitions which will be armed in case of the quick
arming (see: USER MANUAL).
Display entry delay of partitions [Show entry del.] – information on entry delay countdown
in selected partitions can be displayed on the keypad.
Display exit delay of partitions [Show exit delay] – information on exit delay countdown in
selected partitions can be displayed on the keypad.
Signal entry delay of partitions [Sign.entry del.] – the entry delay countdown in selected
partitions can be audibly signaled on the keypad.
Signal exit delay of partitions [Sign.exit delay] – the exit delay countdown in selected
partitions can be audibly signaled on the keypad.
Date/Time format – the format in which the date and time are to be displayed on the keypad.
LCD backlight – selection of the display backlighting type.
Keys backlight – selection of the keypad backlighting type.
Alarm messages
Partitions [Part.al.msg.] – if this option is enabled, messages on partition alarms will be
displayed (they contain the name of partition).
Zones [Zone al.msg.] – if this option is enabled, messages on alarms from zones will be
displayed (they contain the name of zone). The zone alarm messages have the priority.
Alarms
FIRE [Fire alarm] – if this option is enabled, pressing the key for approx. 3 seconds will
trigger the fire alarm.
PANIC [Panic alarm] – if this option is enabled, pressing the key for approx. 3 seconds
will trigger the panic alarm.
AUX. [Medical alarm] – if this option is enabled, pressing the key for approx. 3 seconds
will trigger the medical alarm.
3 wrong codes [3 wrong codes] – if this option is enabled, entering incorrect code three
times will trigger the alarm.
Additional options
Silent PANIC alarm [Silent panic] – if this option is enabled, the panic alarm triggered from
the keypad will be a silent one, i.e. the keypad will not indicate it, there will be no audible
signal, but the alarm will be reported to the monitoring station. The silent panic alarm is
useful when the control panel is sending events to the monitoring station, but unauthorized
persons should not be aware of the alarm being triggered. This option is available when
the PANIC option is enabled.
Sign. alarms [Alarm signal.] – with this option enabled, the keypad will signal the alarms
audibly.
Key sounds [Key sounds] – with this option enabled, pressing the keypad keys is confirmed
by beeps.
Sign. trbl. in part. arm [Trbl.in p.arm.] – if this option is enabled, the LED goes off after
all managed by keypad partitions are armed (if the option is disabled, the LED goes off
after just one of the partitions is armed).
To Next Page
Loading...
