EasyManuals Logo

SATO CG408TT User Manual

SATO CG408TT
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
Section 1: Introduction
Page 1-2 CG4 Series Operator Manual
1.2 UNPACKING
When unpacking the printer, take note of the following:
1. The box should stay right-side up.
Lift the printer out of the box carefully.
2. Remove all the packaging from the printer.
3. Remove the accessory items from their protective containers.
4. Set the printer on a solid, flat surface. Inspect the shipping container and printer for any sign of damage
that may have occurred during shipping. Please note that SATO shall hold no liability of any damage of any
kind sustained during shipping of the product.
Notes
If the printer has been stored in the cold, allow it to reach room temperature before turning it on.
Please do not discard the original packaging box and cushioning material after installing the printer. They
may be needed in future, if the printer needs to be shipped for repairs.
1.2.1 Included Accessories
After unpacking the printer, verify that you have the following materials:
User Documents
(Quick Guide, Warranty, etc)
* The shape of the power plug may vary, depending on the location where it was purchased.
Power plug*
AC adapter

Table of Contents

Other manuals for SATO CG408TT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SATO CG408TT and is the answer not in the manual?

SATO CG408TT Specifications

General IconGeneral
Print MethodThermal Transfer / Direct Thermal
Resolution203 dpi
Max Print Width104 mm
Memory8MB Flash ROM, 16MB SDRAM
Print Speed4 ips
Media SensorReflective and Transmissive
InterfaceUSB, RS232C
Optional InterfacesEthernet
Media TypeRoll, Fanfold
Media Width22 mm to 118 mm
Media Thickness0.06 mm - 0.2 mm
Ribbon Width40 mm to 110 mm
Power SupplyAC 100-240V, 50/60 Hz

Related product manuals