Unit 3: Code Quick Reference
E/Pro Programming Reference
3-9 PN: 9001096E
C Repeat Label. Prints a duplicate of the last label printed.
CBabb Tear-off correction. Corrects tear-off value.
a = Increment or decrement:
+: Increment
-: Decrement
bb = Distance to move (mm): -5 to 98
CIa Sensor selection. Makes minor adjustments of darkness for the best print quality.
a = Sensor type:
0: Sensor is not used.
1: I-mark (CX-compatible)
2: Transmissive
CCa Card, Slot for Use. Selects the memory area for all following expanded memory commands.
a = Memory Area 1
b = Memory Area 2
CLa CR/LF Deletion. Deletes the occurrence of CR/LF characters in the data stream.
a = 0: Do not delete CR/LF
1: Delete CR/LF
CRaaaaabcd Serial port. Sets serial port.
aaaaa = BAUD rate:
9600: 9600 bps
19200: 19200 bps
38400: 38400 bps
b= Parity:
N: Non parity
O: Odd number
E: Even number
c = Data bit:
7: 7 bit
8: 8 bit
d= Stop bit
1: 1 bit
2: 2 bit
CPa Ribbon. Selects the use or disuse of ribbon.
a = Ribbon type:
0: Direct thermal (ribbon is not required)
1: Thermal transfer (ribbon is required)
COMMAND QUICK REFERENCE
INSTRUCTION DESCRIPTION
To Next Page
Loading...
