3 Loading the Ribbon and Media
7 Press the print head down until the head
lock lever is locked.
8 Press the media guide w lightly against the
end of the media, then turn the knob e to
lock the media guide.
9 Close the top cover.
1 0
After loading the media and ribbon, perform
a test print to make sure that the media is
loaded correctly.
2
3
A few things to note: Auto calibrate using both types of sensors with Gap being used
on paper end.
INSTRUCTIONAL VIDEOS
(Click on the video link to view)
CL4NX Ribbon Replacement
CL4NX Label Roll Replacement (Standard)
CL4NX Fanfold Label Replacement (Standard)
CL4NX Cleaning
SOFTWARE & DRIVERS
ADDITIONAL DOCUMENTATION
SATO CL4NX Advanced Operator Manual
SATO CL4NX Tech Tips Guide
Sato Management Tool Windows Driver
To Previous Page
Loading...
