3 Loading the Ribbon and Media
3 Pull the media holder guide q and media
guide w away from the printer.
Turn the knob e counterclockwise to release the
media guide.
4 Load the media in the media holder r.
Make sure that the media roll is all the way
in to inside of the printer.
5 Push the media holder guide q lightly
against the media roll.
6 Pass the media below the media damper
t and media sensor guide y while
pushing the media to inside of the printer.
Make sure that the end of the media extends out the
front of the printer.
2
1
3
4
1
5
6
To Next Page
Loading...
