SATO CL612e - Print Mode Selection; Sensor Type Configuration; Head Check Functionality

Operation Manual 3. Configuration
CL608e/612e 15
Communication Protocol Selection (DSW1-7, DSW1-8)
Selects the flow control and status reporting.
Note: For Status 4 the DSW2-8 must be set to OFF
Print Mode Selection (DSW2-1)
Selects between direct thermal printing on thermally sensitive
paper and thermal transfer printing using a ribbon.
Sensor Type Selection (DSW2-2)
Selects type of sensing.
Head Check Selection (DSW2-3)
When selected, the printer will check for head elements that are
electrically malfunctioned.
* Factory Default
DSW1-7 DSW1-8 SETTING
*OFF *OFF Rdy/Bsy
OFF ON Xon/XOff
ON OFF Status 3
ON ON Status 4
DSW1
ON
OFF
12 34567 8
DSW2-1 SETTING
*OFF Therm Trans
ON Direct Therm
12 345678
ON
OFF
DSW2
DSW2-2 SETTING
*
OFF
Gap
ON “I” Mark
12 345678
ON
OFF
DSW2
ON
OFF
DSW2
12 34567 8
DSW2-3 SETTING
*
OFF
Disabled
ON Enabled