SATO GL408e - 7 Setup and Initial Operation; Connecting the Device; Connecting the Interface Cable; Turning on the Device

GL408e / GL412e Barcode Thermal Printer
Setup and initial operation
7 Setup and initial operation
7.1 Connecting the device
7.1.1 Connecting the interface cable
Fig. 6 Printer main body, back
1. Connect the interface cable to the interface connector (4, 5, 6)
on the printer and to your PC.
2. Lead the interface cable through the cable hook (8) on the
printer.
7.1.2 Turning on the device
1. Connect the power cable to the power supply connector (7) on
the printer and to your power outlet.
2. Lead the power cable through the cable hook (8) on the
printer.
Note!
Use only the power cable included with your
printer.
3. Press the POWER button on "I". The LED "POWER" lights up.
7.1.3 Turning off the device
4. Before turning off the printer, make sure that the printer is
OFFLINE.
If the printer is ONLINE, press the LINE button. "OFFLINE"
will be displayed.
5. Press the POWER button on "0".
7.1.4 Removing the power cable
1. Before removing the power cable, make sure to turn off the
printer by pressing the POWER button.
1
2
1
3
1
4
1
5
1
7
1
8
6
1
13