WS4-DT-r01-30-12-16TM
6. Lift the base and unplug all the cables.
7. Remove the base and the middle frame.
Step 2. Connect the cutter to the main board
This part describes how to thread the cutter cable and wire and connect them to
the main board.
1. Thread the cutter cable and the ground wire (fork terminal) into two square
holes beside the right side of the platen roller.
2. Reinstall the middle frame.
3. Plug the cutter connector to J8, which is the white port located to the right of
the main board. Connect the ground wire to the screw beside J8 after
loosening the screw a bit and then tighten the screw to secure the wire.
4. Plug all other cables back into the main board.
5. Reinstall the base and the secure it with four screws.
6. Turn over your printer and open the top cover.
Step 3. Secure the cutter to your printer
This part describes how to remove the platen roller and secure the cutter to your
printer.
To Next Page
Loading...
