WS4-DT-r01-30-12-16TM
1. Locate two clasps on both sides of the platen roller. Slightly press them inward
and rotate them 90 degrees, so the handles of the clasps point up.
2. Lift the platen roller.
3. Align the two screw holes of the cutter with the screw holes on both sides of
the platen roller and fit the cutter dowel (at the bottom of the cutter) into the
square hole on the middle frame.
4. Secure the cutter with two screws.
5. Reinstall the platen roller.
Step 4. Test the cutter
This part describes how to use the cutter to cut your label.
1. Press the holder lock on the Media Roll Holders to slide them outward, and
place the media roll between the holders. Make sure the print side is up and
the media roll is clamped tightly by the holders.
2. Pull the media until it reaches out of your printer. Thread the media under the
media guides.
3. Thread the media into the slot of the cutter.
4. Close the top cover.
5. Send a print job or press the FEED button to test if the cutter works.
To Next Page
Loading...
