WS4-TT-r01-30-12-16TM
2 Accessories Installation
This chapter describes how to install accessories on the printer.
2.1
Cutter
A cutter is used to cut the label after it is printed out. A full cutter cuts a label off
from a media roll.
To install a full cutter:
Step 1. Remove the tear bar, top cover and middle frame
This part describes how to dismantle your printer.
1. Open the top cover.
2. Press the Module Release Latch to open the print module.
3. Loosen and remove the two screws on each side of the tear bar.
To Next Page
Loading...
