WS4-TT-r01-30-12-16TM
2.6
Paper Support Roller
A paper support roller is used to prevent paper jam. It is placed between the
Media
Shaft and the Media Roll Holders. When paper is moving forward during the
printing, it might be curled or crumpled and cause paper jam. The roller can hold
the paper down to solve this problem. For thermal transfer media, we
recommend you use the paper support roller if the label length is less than 45 mm,
width is less than 50 mm, gap is more than 3 mm, and the media roll is outside
wound.
To install a paper support roller:
1. Insert the right end of the rod to the hole of the right bracket holder.
2. Place the left end of the rod on the left bracket holder.
To Next Page
Loading...
