WS4-TT-r01-30-12-16TM
●
If the inside diameter of the media roll is 1-inch, make sure the Core Holders
are facing inward, and then insert the Roll Stops into each end of the Holder
Shaft.
●
If the inside diameter of the media roll is 3-inch, make sure the Core Holders
are facing outward and then insert the Roll Stops into each end of the Holder
Shaft.
5. Place the Holder Shaft on the Unwinder Holders.
6. Place the printer on the Unwinder Base. Fit the printer’s rear rubber feet into
the Rubber Foot Slots.
7. Attach the power cord and the connection cable to the printer.
8. Pull out the media and thread it through the rear slot of the printer.
To Next Page
Loading...
