WS4-TT-r01-30-12-16TM
3. Plug the Bluetooth cable to J15, which is the black port located to the
lower-right of the main board. Route the Bluetooth cable outside (right) of the
row of connectors.
Step 3. Reinstall the parts you took off
This part describes how to reinstall the parts you took off.
1. Reinstall the print module and the secure it with four screws.
2. Reinstall the middle frame along with the top cover and secure it with four
screws.
3. Reinstall the tear bar and secure it with two screws.
4. Close the top cover.
To Next Page
Loading...
