5. Assemble the complete guard plate over the cylinder of compression
stage 2 and screw in the socket head cap screws. Each socket head
cap screw must be screwed in together with a washer, an insulating
washer and a spacer bush.
6. Assemble condensate separators compression stages 1 and 2
7. Assemble the condensate separator on the cooler housing.
8. Screw in the socket head cap screws on the separator head.
9. Screw in the socket head cap screws on the pressure line flange. Use
new gasket.
10. Assemble and tighten the union for the drainage line on the bottom of
the condensate separator.
11. Assemble condensate separators compression stages 3 and 4
12. Assemble the condensate separator on the cooler insert.
13. Screw in the socket head cap screws on the separator head.
14. Screw the hexagon nut tight.
15. Tighten the unions on the separator head. Use new ring gaskets when
doing this.
16. Assemble and tighten the union for the drainage line on the bottom of
the condensate separator.
17. Assemble pipelines on the separator heads.
18.
Fill with cooling water as described in
Ä
Chapter 3.5 ‘Draining and
refilling cooling water’ on page 13.
4.1.12
Replacing the sacrificial zinc anode
Personnel:
n
Service personnel
Protective equipment:
n
Safety goggles
n
Protective gloves
n
Work clothing
n
Safety boots
There are 2 sacrificial zinc anodes on each cylinder and on each cooler.
MAINTENANCE
WP5000 Basic WA 41013675 en GB 20190916 | 55
To Next Page
Loading...
