The following procedure applies to all sacrificial zinc anodes.
1.
Drain the cooling water as described in
Ä
Chapter 3.5 ‘Draining and
refilling cooling water’ on page 13.
2. Unscrew the sacrificial zinc anode and the ring gasket and dispose of
in an environmentally sound manner.
3. Screw in a new sacrificial zinc anode with a new ring gasket.
4.
Fill with cooling water as described in
Ä
Chapter 3.5 ‘Draining and
refilling cooling water’ on page 13.
4.1.13 Replacing the bursting discs
Personnel:
n
Service personnel
Protective equipment:
n
Safety goggles
n
Protective gloves
n
Work clothing
n
Safety boots
A bursting disc is located on each cooler housing.
Replacing the sacrificial
zinc anodes
MAINTENANCE
WP5000 Basic WA 41013675 en GB 20190916 | 57
To Next Page
Loading...
