Savant PAV-VIM8S - Video;Audio Settings

Savant IP Video Deployment Guide | 009-1977-00 45 Perseverance Way, Hyannis, MA 02601
Copyright 2020 Savant Systems, Inc | 200924 21 of 28 Savant.com | 508.683.2500
7.2. Video/Audio Settings (Output Only)
These settings are only available on output chassis.
4K 1080p
720p
Use Input
Settings
Resolutions
60 Hz 50 Hz
30 Hz
Use Input
Frame Rates
25 Hz 24 Hz
Settings
Path Policy
Downmix
Logical IOs
Video Audio Output 1
Samsung
Resolutions
– Use Input: Will pass the received video resolution to the endpoint.
– 4K: Scale to UHD (3840x2160).
– 1080p: Scale to Full HD (1920x1080)
– 720p: Scale to HD (1280x720)
Frame Rates
– Use Input: Will pass the received video frame rate to the endpoint.
– 60 Hz: Fixed Frame Rate of 60 frames per second.
– 50 Hz: Fixed Frame Rate of 50 frames per second.
– 30 Hz: Fixed Frame Rate of 30 frames per second.
– 25 Hz: Fixed Frame Rate of 25 frames per second.
– 24 Hz: Fixed Frame Rate of 24 frames per second.
Path Policy (PAV-VIMAPxS only) – Dropdown menu with the following options.
– Dynamic: Uses the EDID read from the connected endpoint. If the endpoint EDID
supports the current source’s incoming audio format, the pass-through path will be
used. If the endpoint’s EDID does not support the current source’s incoming audio
format, the down mixed path will be used.
– Pass-thru: Pass-thru the HDMI audio format to the endpoint.
– Downmix: Uses audio processing to downmix the audio to 2 channel PCM.
Path Policy (PAV-VIMxS/PAV-VIM1C/PAV-VIMVP1x) – Dropdown menu with the following options.
– Dynamic: Enables the multi-channel to 2 channel PCM.
– Pass-thru: Pass-through the HDMI audio format to the endpoint.
– Downmix: Enables the multi-channel to 2 channel PCM.
IMPORTANT!
– This will only downmix Multi-channel PCM audio to Stereo PCM. It is not compatible with encoded Bit stream audio formats.
– Routing Bitstream audio from any non-audio processing device to a PAV-VOM device that has an audio configuration setting of Dynamic
or Down mix will result in no audio from the PAV-VOM. To support bitstream audio from any non-audio processing device, the PAV-VOM
device should be configured with a Pass-through audio setting in the AVoIP Info tab of System Monitor.
NOTE: Scaling HDCP 2.2 sources to an HDCP 1.4 sync device requires the resolution input of the HDCP 2.2 source to be 4K 60 4:2:0 8Bit or below.
For a basic understanding of how these options aect the system review the information below: