SawStop 10” Contractor Saw 3
Table of Contents
Using Your Saw 41
Adjusting the Blade Height 41
Adjusting the Blade Tilt Angle 41
Turning on Main Power and Starting the Motor 42
System Status Codes 44
Using the Blade Guard 47
Using the Riving Knife 49
Using the Miter Gauge 49
Cross-Cutting 51
Using a Fence 52
Rip Cutting 53
Using the Saw in Bypass Mode 55
Using a Mobile Base or a Job Site Cart 56
Using an Out-Feed Table 57
The SawStop
®
Brake Cartridge 58
Changing the Brake Cartridge 59
Installing a Brake Cartridge 62
What to do if the SawStop
®
Safety System Activates 63
Making Adjustments to Your Saw 64
Adjusting the Elevation Limit Stops 64
Adjusting the Tilt Limit Stops and Tilt Angle Indicator 66
Adjusting the Table Insert 68
Aligning the Riving Knife and Spreader to the Blade 70
Adjusting the Height of the Riving Knife 71
Adjusting the Quick-Release Clamp 73
Adjusting the Miter Gauge 74
Maintenance 75
SawStop Safety System 75
Brake Cartridge 75
Elevation and Tilt Mechanisms 75
Table and Extension Wings 75
Motor Belt 75
To Next Page
Loading...
